0 items in cart
soap Weight 6 oz
Dimensions: 1 1/4" wide x 3/4" diam by 12" tall
Our 2 piece column silicone mold. The pieces snap together. great Use a couple of clips to ensure there is no leakage.
When pouring soap batter use a cup or glass to hold it up.
Directions:Melt & Pour Soap: Close the mold by firmly pressing the edges together. For added safety, clamp the edges. Slowly pour melted soap no hotter than 130ºF into mold. Allow soap to harden then open mold and remove soap. Trim edges with a potato peeler or spatula. Embed soap into a loaf or slice into bars. Cold Process Soap: Close the mold by firmly pressing the edges together, and clamp the edges. Slowly pour traced soap into mold. After at least 24 hours, open mold and remove soap with gloved hands. Trim edges with a potato peeler or spatula. Embed soap into a loaf or slice into bars. Allow soap to cure for 4-8 weeks. Note that some cp soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster. Care:Hand wash mold in warm, sudsy water.
It would be difficult to fill with hot process soap however do not see a problem if done in CP and added to HP soap loaf mold
© 1998 - 2020 Soap & More. All rights reserved.
3830 - 7th St. SE Calgary, Alberta Canada T2G 2Y8 (Open to public during store hours)
Phone: 403-217-2346 Toll Free 888-918-2346
Powered by X-Cart